DASMA Standards

Reference articles on dasma standards. Each one cites the original standard or code it is based on.

Showing 14 articles

DASMA Standards

ANSI/DASMA 102 - Specifications for Sectional Overhead-Type Doors

ANSI/DASMA 102-2018 sets the product specifications for sectional overhead doors: dimensions, materials, hardware, hardware attachment, and performance.

ANSI/DASMA 103 - Standard for Counterbalance Systems on Residential Sectional Garage Doors

ANSI/DASMA 103-2017 sets minimum requirements for torsion springs, extension springs, cables, and drums used in residential garage door counterbalance systems.

ANSI/DASMA 105 - Test Method for Thermal Transmittance and Air Infiltration of Garage Doors

ANSI/DASMA 105-2017 is the test method used to measure the U-factor and air infiltration rate of an insulated garage door.

ANSI/DASMA 107 - Room Fire Test Standard for Garage Doors Using Foam Plastic Insulation

ANSI/DASMA 107-2012 is the room fire test standard for insulated garage doors that use foam plastic cores.

ANSI/DASMA 108 - Structural Performance Testing for Sectional Garage and Rolling Doors Under Wind Load

ANSI/DASMA 108-2017 is the wind-load test method for sectional garage doors and rolling doors.

ANSI/DASMA 109 - Standard Method for Testing and Rating Sectional Garage Door Cycle Life

ANSI/DASMA 109-2017 is the cycle-life test standard for sectional garage doors.

ANSI/DASMA 110 - Standard for Lifting Cables for Sectional Garage Doors

ANSI/DASMA 110-2025 sets minimum requirements for the lifting cables used in sectional garage door counterbalance systems.

ANSI/DASMA 115 - Impact and Cyclic Wind Test for Windborne-Debris-Rated Garage Doors

ANSI/DASMA 115-2017 is the missile impact and cyclic wind test for sectional garage doors in windborne debris regions.

ANSI/DASMA 116 - Standard for Section Interfaces on Residential Garage Door Systems

ANSI/DASMA 116-2018 defines the dimensional and performance requirements for the joints between sections in residential sectional garage doors.

ANSI/DASMA 203 - Standard for Non-Fire-Rated Rolling Doors

ANSI/DASMA 203-2004 is the product standard for non-fire-rated rolling steel doors.

ANSI/DASMA 207 - Standard for Rolling Sheet Doors

ANSI/DASMA 207-2020 sets minimum requirements for rolling sheet doors: single-sheet steel or aluminum curtains that coil above the opening without interlocking slats.

ANSI/DASMA 208 - Standard for Rolling Grilles

ANSI/DASMA 208-2018 sets minimum requirements for rolling grilles: open-mesh curtains used on storefronts and commercial openings where visibility and air flow are needed after hours.

DASMA 402 - Specification for High Performance Doors and Grilles

DASMA 402 sets the specification for high-performance doors and grilles: products designed for frequent cycling, high-speed operation, and demanding industrial or commercial environments.

DASMA 403 - Specification for High Speed Doors

DASMA 403 sets the specification for high-speed doors: commercial and industrial doors that operate at opening speeds of 20 inches per second or faster.

Have a code or compliance question?

We work to Colorado and Denver-metro requirements every day. Call us and we will point you in the right direction.

Call (720) 421-6489 Get a Free Estimate